arndale : passed 0:51.21 bbb : FAILED 1:04.49 beaver : passed 0:57.68 multi-beaver : passed 0:38.81 cubie : passed 0:58.01 cubie2 : passed 0:56.52 cubox : passed 0:54.47 panda : passed 2:53.57 multi-panda : passed 2:48.34 sama5 : passed 1:50.41 snowball : passed 1:13.25 multi-snowball : passed 0:37.16 multi-trimslice : passed 0:40.76 wandboard : passed 1:12.61 multi-wandboard : passed 0:40.65

Board legend:

Board : System SoC Defconfig

arndale : InSignal ArndaleBoard Samsung Exynos 5250 exynos_defconfig bbb : BeagleBone Black TI Sitara AM3359 omap2plus_defconfig beaver : Nvidia Beaver Nvidia Tegra 30 tegra_defconfig multi-beaver : multi_v7_defconfig cubie : Cubieboard Allwinner A10 multi_v7_defconfig cubie2 : Cubieboard 2 Allwinner A20 multi_v7_defconfig cubox : SolidRun Cubox Marvell 88AP510 dove_defconfig multi-trimslice : CompuLab TrimSlice Nvidia Tegra 20 multi_v7_defconfig panda : TI PandaBoard ES TI OMAP4460 omap2plus_defconfig multi-panda : multi_v7_defconfig sama5 : Atmel SAMA5 devboard Atmel SAMA5D35 sama5_defconfig snowball : CALAO Snowball ST-Ericsson A9500 u8500_defconfig multi-snowball : multi_v7_defconfig wandboard : Wandboard Freescale i.MX6 Quad imx_v6_v7_defconfig multi-wandboard : multi_v7_defconfig

Last entries of failed logs below:

========================================================================

Board bbb failure log: -------------------------------------------------

cpsw, usb_ether Hit any key to stop autoboot: 1  0 U-Boot# version version

U-Boot 2013.04-00017-g5c4fa11 (May 03 2013 - 10:48:32) arm-linux-gnueabihf-gcc (crosstool-NG linaro-1.13.1-4.7-2013.03-20130313 - Linaro GCC 2013.03) 4.7.3 20130226 (prerelease) GNU ld (crosstool-NG linaro-1.13.1-4.7-2013.03-20130313 - Linaro GCC 2013.03) 2.23.1 U-Boot# usb start usb start (Re)start USB... USB0: node: bbb status: on lowlevel init failed USB error: all controllers failed lowlevel init U-Boot# setenv autoload no setenv autoload no U-Boot# dhcp dhcp link up on port 0, speed 1000, full duplex BOOTP broadcast 1 BOOTP broadcast 2 BOOTP broadcast 3 BOOTP broadcast 4 BOOTP broadcast 5 BOOTP broadcast 6 BOOTP broadcast 7 BOOTP broadcast 8 BOOTP broadcast 9 BOOTP broadcast 10

Retry count exceeded; starting again using musb-hdrc, OUT ep1out IN ep1in STATUS ep2in MAC bc:6a:29:7a:42:a8 HOST MAC de:ad:be:af:00:00 RNDIS ready ERROR: The remote end did not respond in time. at ether.c:2395/usb_eth_init() link up on port 0, speed 1000, full duplex ~$off