Tree/Branch: mainline Git describe: v3.15-rc6 Failed boot tests (console logs at the end) =========================================== omap4-panda-es: FAIL: arm-multi_v7_defconfig

Full Report ===========

arm-tegra_defconfig ------------------- tegra30-beaver 0 min 24.8 sec: PASS

arm-multi_v7_defconfig+CONFIG_ARM_LPAE=y ---------------------------------------- armada-xp-openblocks-ax3-4 0 min 27.0 sec: PASS omap5-uevm 1 min 34.7 sec: PASS sun7i-a20-cubieboard2 0 min 11.7 sec: PASS

arm-multi_v7_defconfig ---------------------- ste-snowball 1 min 18.0 sec: PASS tegra30-beaver 0 min 17.2 sec: PASS omap3-overo-storm-tobi 0 min 23.9 sec: PASS sun7i-a20-cubieboard2 0 min 12.4 sec: PASS qcom-apq8074-dragonboard 0 min 16.9 sec: PASS omap4-panda 0 min 54.4 sec: PASS armada-xp-openblocks-ax3-4 0 min 25.1 sec: PASS omap3-overo-tobi 0 min 22.0 sec: PASS (Warnings: 1) am335x-bone 0 min 37.0 sec: PASS armada-370-mirabox 0 min 22.4 sec: PASS omap3-n900 0 min 16.3 sec: PASS (Warnings: 1) omap4-panda-es 2 min 18.9 sec: FAIL

arm-sunxi_defconfig ------------------- sun7i-a20-cubieboard2 0 min 10.9 sec: PASS sun4i-a10-cubieboard 0 min 12.9 sec: PASS

arm-bcm_defconfig ----------------- bcm28155-ap 0 min 23.1 sec: PASS

arm-exynos_defconfig -------------------- exynos5420-arndale-octa 0 min 36.3 sec: PASS exynos5250-arndale 0 min 29.8 sec: PASS

arm-sama5_defconfig ------------------- sama5d35ek 0 min 17.3 sec: PASS

Console logs for failures =========================

arm-multi_v7_defconfig ----------------------

omap4-panda-es: FAIL: last 40 lines of boot log: ------------------------------------------------

[ 1.794403] twl 0-0048: PIH (irq 39) nested IRQs [ 1.800720] twl_rtc rtc.15: Enabling TWL-RTC [ 1.807556] twl_rtc rtc.15: rtc core: registered rtc.15 as rtc0 [ 1.814666] VAUX1_6030: 1000 <--> 3000 mV at 2800 mV [ 1.820800] VAUX2_6030: 1200 <--> 2800 mV at 1800 mV [ 1.826904] VAUX3_6030: 1000 <--> 3000 mV at 1200 mV [ 1.833007] VMMC: 1200 <--> 3000 mV at 3000 mV [ 1.838531] VPP: 1800 <--> 2500 mV at 1900 mV [ 1.844024] VUSIM: 1200 <--> 2900 mV at 1800 mV [ 1.849182] VDAC: 1800 mV [ 1.849548] VANA: 2100 mV [ 1.856414] VCXIO: 1800 mV [ 1.856414] VUSB: 3300 mV [ 1.863433] V1V8: 1800 mV [ 1.867004] V2V1: 2100 mV [ 1.874603] omap_i2c 48070000.i2c: bus 0 rev0.11 at 400 kHz [ 1.958679] usb 1-1: new high-speed USB device number 2 using ehci-omap [ 2.125701] gic_timer_retrigger: lost localtimer interrupt [ 2.131530] hub 1-1:1.0: USB hub found [ 2.136016] gic_timer_retrigger: lost localtimer interrupt [ 2.141876] hub 1-1:1.0: 5 ports detected [ 2.190032] omap_i2c 48072000.i2c: bus 1 rev0.11 at 400 kHz [ 2.439483] usb 1-1.1: new high-speed USB device number 3 using ehci-omap [ 2.490386] omap_i2c 48060000.i2c: bus 2 rev0.11 at 100 kHz [ 2.582702] smsc95xx v1.0.4 [ 2.656219] smsc95xx 1-1.1:1.0 eth0: register 'smsc95xx' at usb-4a064c00.ehci-1.1, smsc95xx USB 2.0 Ethernet, d6:88:9a:f3:51:0f [ 2.819641] omap_i2c 48350000.i2c: bus 3 rev0.11 at 400 kHz [ 2.829956] omap_hsmmc 4809c000.mmc: pins are not configured from the driver [ 3.028015] twl_rtc rtc.15: setting system clock to 2000-01-28 08:17:48 UTC (949047468) [ 3.048400] mmc0: host does not support reading read-only switch. assuming write-enable. [ 3.058959] mmc0: new high speed SDHC card at address 1234 [ 3.065216] mmcblk0: mmc0:1234 SA04G 3.63 GiB [ 3.071655] mmcblk0: p1 p2 [ 3.079772] omap_hsmmc 480d5000.mmc: card claims to support voltages below defined range [ 3.097961] mmc1: queuing unknown CIS tuple 0x91 (3 bytes) [ 3.104614] mmc1: new SDIO card at address 0001 ~$off # PYBOOT: Exception: kernel: ERROR: failed to boot: <class 'pexpect.TIMEOUT'> # PYBOOT: Time: 138.94 seconds. # PYBOOT: Result: FAIL