hi,
man ip, the output about exit value is like following. "Exit status is 0 if command was successful, and 1 if there is a syntax error. If an error was reported by the kernel exit status is 2." Did the following COMMAND have syntax error? If not, should I still change the expected rc from 2 to 1?
####################################################### HINT: Fails since VRF device does not support linklocal or multicast
COMMAND: ip netns exec ns-A /bin/ping6 -c1 -w1 fe80::7c4c:bcff:fe66:a63a%red ping: sendmsg: Network is unreachable PING fe80::7c4c:bcff:fe66:a63a%red(fe80::7c4c:bcff:fe66:a63a%red) 56 data bytes
--- fe80::7c4c:bcff:fe66:a63a%red ping statistics --- 1 packets transmitted, 0 received, 100% packet loss, time 0ms
TEST: ping out, VRF bind - ns-B IPv6 LLA [FAIL]
####################################################### HINT: Fails since VRF device does not support linklocal or multicast
COMMAND: ip netns exec ns-A /bin/ping6 -c1 -w1 ff02::1%red ping: sendmsg: Network is unreachable PING ff02::1%red(ff02::1%red) 56 data bytes
--- ff02::1%red ping statistics --- 1 packets transmitted, 0 received, 100% packet loss, time 0ms
TEST: ping out, VRF bind - multicast IP [FAIL]
#######################################################
best regards,
________________________________________ From: David Ahern dsahern@gmail.com Sent: Wednesday, December 8, 2021 11:20 AM To: Jakub Kicinski; lizhijian@fujitsu.com Cc: Zhou, Jie2X; davem@davemloft.net; shuah@kernel.org; netdev@vger.kernel.org; linux-kselftest@vger.kernel.org; linux-kernel@vger.kernel.org; Li, Philip; lkp; Ma, XinjianX; Li, ZhijianX Subject: Re: selftests/net/fcnal-test.sh: ipv6_ping test failed
On 12/7/21 8:58 AM, Jakub Kicinski wrote:
Adding David and Zhijian.
On Tue, 7 Dec 2021 07:07:40 +0000 Zhou, Jie2X wrote:
hi,
I test ipv6_ping by "./fcnal-test.sh -v -t ipv6_ping". There are two tests failed.
TEST: ping out, VRF bind - ns-B IPv6 LLA [FAIL] TEST: ping out, VRF bind - multicast IP [FAIL]
While in fcnal-test.sh the expected command result is 2, the result is 1, so the test failed. ipv6_ping_vrf() { ...... for a in ${NSB_LINKIP6}%${VRF} ${MCAST}%${VRF} do log_start show_hint "Fails since VRF device does not support linklocal or multicast" run_cmd ${ping6} -c1 -w1 ${a} log_test_addr ${a} $? 2 "ping out, VRF bind" done
The ipv6_ping test output is attached. Did I set something wrong result that these tests failed?
best regards,
ping6 is failing as it should. Can you send a patch to change the expected rc from 2 to 1?