FEAT_TRF is a Coresight feature that allows trace capture to be completely filtered at different exception levels, unlike the existing TRCVICTLR controls which may still emit target addresses of branches, even if the following trace is filtered.
Without FEAT_TRF, it was possible to start a trace session on a host and also collect trace from the guest as TRCVICTLR was never programmed to exclude guests (and it could still emit target addresses even if it was).
With FEAT_TRF, the current behavior of trace in guests exists depends on whether nVHE or VHE are being used. Both of the examples below are from the host's point of view, as Coresight isn't accessible from guests. This patchset is only relevant to when FEAT_TRF exists, otherwise there is no change.
Current behavior:
nVHE/pKVM:
Because the host and the guest are both using TRFCR_EL1, trace will be generated in guests depending on the same filter rules the host is using. For example if the host is tracing userspace only, then guest userspace trace will also be collected.
(This is further limited by whether TRBE is used because an issue with TRBE means that it's completely disabled in nVHE guests, but it's possible to have other tracing components.)
VHE:
With VHE, the host filters will be in TRFCR_EL2, but the filters in TRFCR_EL1 will be active when the guest is running. Because we don't write to TRFCR_EL1, guest trace will be completely disabled.
New behavior:
The guest filtering rules from the Perf session are now honored for both nVHE and VHE modes. This is done by either writing to TRFCR_EL12 at the start of the Perf session and doing nothing else further, or caching the guest value and writing it at guest switch for nVHE. In pKVM, trace is now be disabled for both protected and unprotected guests.
There is also an optimization where the Coresight drivers pass their enabled state to KVM. This means in the common case KVM doesn't have to touch any sysregs when the feature isn't in use.
Applies to kvmarm/next (60ad25e14a) but includes two commits from Oliver for a conflicting change to move TRBE and SPE flags to host data [7].
---
Changes since V7 [6]: * Drop SPE changes * Change the interface to be based on intent, i.e kvm_enable_trbe() rather than passing the raw register value * Drop change to re-use vcpu_flags mechanism in favour of [7] * Simplify by using the same switch function to and from guest
Changes since V6 [5]: * Implement a better "do nothing" case where both the SPE and Coresight drivers give the enabled state to KVM, allowing some register reads to be dropped. * Move the state and feature flags out of the vCPU into the per-CPU host_debug_state. * Simplify the switch logic by adding a new flag HOST_STATE_SWAP_TRFCR and only storing a single TRFCR value. * Rename vcpu flag macros to a more generic kvm_flag...
Changes since V5 [4]: * Sort new sysreg entries by encoding * Add a comment about sorting arch/arm64/tools/sysreg * Warn on preemptible() before calling smp_processor_id() * Pickup tags * Change TRFCR_EL2 from SysregFields to Sysreg because it was only used once
Changes since V4 [3]: * Remove all V3 changes that made it work in pKVM and just disable trace there instead * Restore PMU host/hyp state sharing back to how it was (kvm_pmu_update_vcpu_events()) * Simplify some of the duplication in the comments and function docs * Add a WARN_ON_ONCE() if kvm_etm_set_guest_trfcr() is called when the trace filtering feature doesn't exist. * Split sysreg change into a tools update followed by the new register addition
Changes since V3: * Create a new shared area to store the host state instead of copying it before each VCPU run * Drop commit that moved SPE and trace registers from host_debug_state into the kvm sysregs array because the guest values were never used * Document kvm_etm_set_guest_trfcr() * Guard kvm_etm_set_guest_trfcr() with a feature check * Drop Mark B and Suzuki's review tags on the sysreg patch because it turned out that broke the Perf build and needed some unconventional changes to fix it (as in: to update the tools copy of the headers in the same commit as the kernel changes)
Changes since V2:
* Add a new iflag to signify presence of FEAT_TRF and keep the existing TRBE iflag. This fixes the issue where TRBLIMITR_EL1 was being accessed even if TRBE didn't exist * Reword a commit message
Changes since V1:
* Squashed all the arm64/tools/sysreg changes into the first commit * Add a new commit to move SPE and TRBE regs into the kvm sysreg array * Add a comment above the TRFCR global that it's per host CPU rather than vcpu
Changes since nVHE RFC [1]:
* Re-write just in terms of the register value to be written for the host and the guest. This removes some logic from the hyp code and a value of kvm_vcpu_arch:trfcr_el1 = 0 no longer means "don't restore". * Remove all the conditional compilation and new files. * Change the kvm_etm_update_vcpu_events macro to a function. * Re-use DEBUG_STATE_SAVE_TRFCR so iflags don't need to be expanded anymore. * Expand the cover letter.
Changes since VHE v3 [2]:
* Use the same interface as nVHE mode so TRFCR_EL12 is now written by kvm.
[1]: https://lore.kernel.org/kvmarm/20230804101317.460697-1-james.clark@arm.com/ [2]: https://lore.kernel.org/kvmarm/20230905102117.2011094-1-james.clark@arm.com/ [3]: https://lore.kernel.org/linux-arm-kernel/20240104162714.1062610-1-james.clar... [4]: https://lore.kernel.org/all/20240220100924.2761706-1-james.clark@arm.com/ [5]: https://lore.kernel.org/linux-arm-kernel/20240226113044.228403-1-james.clark... [6]: https://lore.kernel.org/kvmarm/20241112103717.589952-1-james.clark@linaro.or... [7]: https://lore.kernel.org/kvmarm/20241115224924.2132364-4-oliver.upton@linux.d...
James Clark (6): arm64/sysreg: Add a comment that the sysreg file should be sorted tools: arm64: Update sysreg.h header files arm64/sysreg/tools: Move TRFCR definitions to sysreg KVM: arm64: coresight: Give TRBE enabled state to KVM KVM: arm64: Support trace filtering for guests coresight: Pass guest TRFCR value to KVM
Oliver Upton (2): KVM: arm64: Get rid of __kvm_get_mdcr_el2() and related warts KVM: arm64: Track presence of SPE/TRBE in kvm_host_data instead of vCPU
arch/arm64/include/asm/kvm_asm.h | 5 +- arch/arm64/include/asm/kvm_host.h | 39 +- arch/arm64/include/asm/sysreg.h | 12 - arch/arm64/kvm/arm.c | 5 +- arch/arm64/kvm/debug.c | 92 ++-- arch/arm64/kvm/hyp/nvhe/debug-sr.c | 61 +-- arch/arm64/kvm/hyp/nvhe/hyp-main.c | 6 - arch/arm64/kvm/hyp/vhe/debug-sr.c | 5 - arch/arm64/tools/sysreg | 38 ++ .../coresight/coresight-etm4x-core.c | 43 +- drivers/hwtracing/coresight/coresight-etm4x.h | 2 +- drivers/hwtracing/coresight/coresight-priv.h | 3 + drivers/hwtracing/coresight/coresight-trbe.c | 5 + tools/arch/arm64/include/asm/sysreg.h | 410 +++++++++++++++++- tools/include/linux/kasan-tags.h | 15 + 15 files changed, 609 insertions(+), 132 deletions(-) create mode 100644 tools/include/linux/kasan-tags.h