Failed boards:
bbb multi_v7_defconfig : FAILED 1:19.64 panda multi_v7_defconfig : FAILED 1:41.59
Successful boards:
apc vt8500_v6_v7_defconfig : passed 1:12.51 arndale exynos_defconfig : passed 1:01.41 bbb omap2plus_defconfig : passed 1:28.86 beaver tegra_defconfig : passed 0:54.55 beaver multi_v7_defconfig : passed 0:55.16 capri bcm_defconfig : passed 0:41.41 capri multi_v7_defconfig : passed 0:44.57 cubie sunxi_defconfig : passed 0:50.55 cubie multi_v7_defconfig : passed 0:53.07 cubie2 sunxi_defconfig : passed 0:52.81 cubie2 multi_v7_defconfig : passed 1:02.90 cubie2 multi_lpae_defconfig : passed 0:54.88 cubox dove_defconfig : warnings 1:09.88 dalmore tegra_defconfig : passed 1:21.88 dalmore multi_v7_defconfig : passed 1:15.76 dalmore multi_lpae_defconfig : passed 1:16.60 panda omap2plus_defconfig : passed 1:18.80 sama5 sama5_defconfig : passed 1:50.66 seaboard tegra_defconfig : passed 1:00.85 seaboard multi_v7_defconfig : passed 1:08.64 snow exynos_defconfig : passed 1:20.06 snowball u8500_defconfig : passed 1:29.61 snowball multi_v7_defconfig : passed 2:08.09 trimslice tegra_defconfig : passed 1:41.66 trimslice multi_v7_defconfig : passed 1:02.69 wandboard imx_v6_v7_defconfig : passed 0:57.83 wandboard multi_v7_defconfig : passed 1:06.81
Board legend is available at http://arm-soc.lixom.net/boards.html
Last entries of failed logs below:
========================================================================
Board bbb-multi_v7_defconfig failure log: -------------------------------------------------
TFTP from server 172.16.1.3; our IP address is 172.16.1.117 Filename 'arm-soc/v3.13-rc4-696-g0a8842b/multi_v7_defconfig/zImage'. Load address: 0x80200000 Loading: *################################################################# ################################################################# ################################################################# ################################################################# ##################################### 1.2 MiB/s done Bytes transferred = 4350136 (4260b8 hex) U-Boot# setenv serverip 172.16.1.3 setenv serverip 172.16.1.3node: bbb status: on
U-Boot# tftp 0x81f00000 arm-soc/v3.13-rc4-696-g0a8842b/multi_v7_defconfig/dtbs/am335x-boneblack.dtb tftp 0x81f00000 arm-soc/v3.13-rc4-696-g0a8842b/multi_v7_defconfig/dtbs/am335x-boneblack.dtb link up on port 0, speed 100, full duplex Using cpsw device TFTP from server 172.16.1.3; our IP address is 172.16.1.117 Filename 'arm-soc/v3.13-rc4-696-g0a8842b/multi_v7_defconfig/dtbs/am335x-boneblack.dtb'. Load address: 0x81f00000 Loading: *## 499 KiB/s done Bytes transferred = 17911 (45f7 hex) U-Boot# setenv bootargs console=ttyO0,115200 root=/dev/mmcblk0p2 rootwait rw debug earlyprintk setenv bootargs console=ttyO0,115200 root=/dev/mmcblk0p2 rootwait rw debug earlyprintk U-Boot# printenv bootargs printenv bootargs bootargs=console=ttyO0,115200 root=/dev/mmcblk0p2 rootwait rw debug earlyprintk U-Boot# bootz 0x80200000 - 0x81f00000 bootz 0x80200000 - 0x81f00000 ## Flattened Device Tree blob at 81f00000 Booting using the fdt blob at 0x81f00000 Using Device Tree in place at 81f00000, end 81f075f6
Starting kernel ...
~$off # PYBOOT: Exception: timeout
========================================================================
Board panda-multi_v7_defconfig failure log: -------------------------------------------------
[ 1.414672] omap-dma-engine 4a056000.dma-controller: freeing channel for 62 [ 1.421966] platform 4809c000.mmc: Driver omap_hsmmc requests probe deferral [ 1.429382] omap_hsmmc 480d5000.mmc: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_wl12xx_pins, deferring probe [ 1.441192] platform 480d5000.mmc: Driver omap_hsmmc requests probe deferral [ 1.448822] sdhci-pltfm: SDHCI platform and OF driver helper [ 1.455535] usbcore: registered new interface driver usbhid [ 1.461364] usbhid: USB HID core driver [ 1.468292] TCP: cubic registered [ 1.471740] NET: Registered protocol family 17 [ 1.476593] Key type dns_resolver registered [ 1.481445] Power Management for TI OMAP4+ devices. [ 1.486572] Power Management for TI OMAP4. [ 1.490844] OMAP4 PM: u-boot >= v2012.07 is required for full PM support [ 1.497955] Registering SWP/SWPB emulation handler [ 1.503936] reg-fixed-voltage wl12xx_vmmc.10: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_wl12xx_gpio, deferring probe [ 1.516662] platform wl12xx_vmmc.10: Driver reg-fixed-voltage requests probe deferral [ 1.523895] omap_i2c 48070000.i2c: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_i2c1_pins, deferring probe [ 1.536804] platform 48070000.i2c: Driver omap_i2c requests probe deferral [ 1.544342] omap_i2c 48072000.i2c: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_i2c2_pins, deferring probe [ 1.555847] platform 48072000.i2c: Driver omap_i2c requests probe deferral [ 1.563110] omap_i2c 48060000.i2c: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_i2c3_pins, deferring probe [ 1.574920] platform 48060000.i2c: Driver omap_i2c requests probe deferral [ 1.582458] omap_i2c 48350000.i2c: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_i2c4_pins, deferring probe [ 1.593963] platform 48350000.i2c: Driver omap_i2c requests probe deferral [ 1.601745] omap-dma-engine 4a056000.dma-controller: allocating channel for 62 [ 1.609436] omap-dma-engine 4a056000.dma-controller: allocating channel for 61 [ 1.617065] omap_hsmmc 4809c000.mmc: vmmc regulator missing [ 1.617156] omap-dma-engine 4a056000.dma-controller: freeing channel for 61 [ 1.630249] omap-dma-engine 4a056000.dma-controller: freeing channel for 62 [ 1.637603] platform 4809c000.mmc: Driver omap_hsmmc requests probe deferral [ 1.637664] omap_hsmmc 480d5000.mmc: could not find pctldev for node /ocp/pinmux@4a100040/pinmux_wl12xx_pins, deferring probe [ 1.657196] platform 480d5000.mmc: Driver omap_hsmmc requests probe deferral [ 1.664978] /home/build/work/batch/drivers/rtc/hctosys.c: unable to open rtc device (rtc0) [ 1.673645] spear_cpufreq: Invalid cpufreq_tbl [ 1.678314] ALSA device list: [ 1.681640] No soundcards found. [ 1.681640] omap_uart 48020000.serial: no wakeirq for uart2 [ 1.691528] Waiting for root device /dev/mmcblk0p2... ~$off # PYBOOT: Exception: timeout