Hi,
On 01/14/2015 09:24 AM, Javier Martinez Canillas wrote:
On 01/14/2015 01:19 AM, Javier Martinez Canillas wrote:
I dug further on this issue and found that the cause is that the exynos_mixer driver needs some clocks (CLK_HDMI and CLK_SCLK_HDMI) grabbed by exynos_hdmi to be kept enabled after hdmi_poweroff (drivers/gpu/drm/exynos/exynos_hdmi.c).
Otherwise, any access to mixer device registers leads to an imprecise external abort error. The following change [0] to the Exynos DRM HDMI driver makes the issue to not happen and I can successfully execute:
# echo 1 > /sys/devices/platform/exynos-drm/graphics/fb0/blank # echo 0 > /sys/devices/platform/exynos-drm/graphics/fb0/blank
Did you execute this operation repeatedly? Still i get error when i execute this more than twice with your change [0].
Thanks.
Only not disabling the hdmi clock [1]: is enough but doing so makes sometimes the DISP1 power domain disabling fails. It doesn't seem to have side effect though since I also see the signal in the HDMI display to go standby and then on again.
# echo 0 > /sys/devices/platform/exynos-drm/graphics/fb0/blank # echo 1 > /sys/devices/platform/exynos-drm/graphics/fb0/blank [ 63.089080] Power domain disp1-power-domain disable failed # echo 0 > /sys/devices/platform/exynos-drm/graphics/fb0/blank #
That error message when both clocks are not disabled on hdmi_poweroff() though.
This should be: "That error message is not shown when both clocks are disabled".
Best regards, Javier