On 26/06/2024 10:30, Alexandre Mergnat wrote:

On 25/06/2024 15:44, Krzysztof Kozlowski wrote:

...

On 25/06/2024 11:23, Alexandre Mergnat wrote:

...

On 21/06/2024 17:00, Krzysztof Kozlowski wrote:

...

On 19/06/2024 16:46, Alexandre Mergnat wrote:

...

Add the audio codec sub-device. This sub-device is used to set the optional voltage values according to the hardware. The properties are: - Setup of microphone bias voltage. - Setup of the speaker pin pull-down.

Also, add the audio power supply property which is dedicated for the audio codec sub-device.

Signed-off-by: Alexandre Mergnatamergnat@baylibre.com

.../devicetree/bindings/mfd/mediatek,mt6357.yaml | 33 ++++++++++++++++++++++ 1 file changed, 33 insertions(+)

diff --git a/Documentation/devicetree/bindings/mfd/mediatek,mt6357.yaml b/Documentation/devicetree/bindings/mfd/mediatek,mt6357.yaml index 37423c2e0fdf..d95307393e75 100644 --- a/Documentation/devicetree/bindings/mfd/mediatek,mt6357.yaml +++ b/Documentation/devicetree/bindings/mfd/mediatek,mt6357.yaml @@ -37,6 +37,32 @@ properties: "#interrupt-cells": const: 2

• vaud28-supply:
• description: 2.8 volt supply phandle for the audio codec
• audio-codec:
• type: object

Still not much improved. You do not have any resources there, so these should go to the parent node.

Hi Krzysztof,

vaud28-supply seems to be a mistake that I forward port. In the V4, AFAII, your feedback [1] suggested me to move the vaud28-supply from the "audio-codec" sub-node to the parent node, which for me is the "pmic" (mfd), because the property is considered as power-supply.

  pwrap {
      pmic {
          ...
          audio-codec {
              ...

Hardware side, vaud28-supply is the output of PMIC-regulator subsystem, and AVDD28 is the input of PMIC-audio-codec subsystem. Then:

• The property name is wrong and must be change to AVDD28, which is a consumer (power input), not a

power-supply. => description: 2.8 volt power input for microphones (AU_VIN0, AU_VIN1, AU_VIN2)

• IMHO, move this property to the next parent (pwrap) isn't consistent. It should be moved back to

Documentation/devicetree/bindings/mfd/mediatek,mt6357.yaml (Done in the V4) into audio-codec substystem, beside mediatek,micbias0-microvolt

I don't understand why do we talk again about supply. My comment was not under the supply.

Because your word are: " And now you should see how odd it looks. Supplies are part of entire chip, not subblock, even if they supply dedicated domain within that chip.

That's why I asked to put it in the parent node. "

My bad, I forgot to link you the old message in my previous answer [1]

[1] https://lore.kernel.org/all/6d21da37-8be7-467c-8878-d57af0b0201b@kernel.org/...

And you implemented this, so why do we talk again about it? It is already solved, isn't it? Since previous version?

Best regards, Krzysztof