Hi,
The current AARCH64 UEFI is designed to run entirely in EL2 with the assumption that the ARM Trusted FW (ATF) running in EL3 and launching UEFI in EL2.
As a result if we try to use the UEFI bootloader as a bare-metal debug tool (w/o the ATF, BootROM and so on..), we get an assertion failure in ArmConfigureMmu call (PEI phase).
"UEFI should not run in EL3".
However when I look at 'ArmPkg/Library/ArmLib/Common/AArch64/ArmLibSupport.S', I see some function implementations support UEFI running in EL3...
ASM_PFX(ArmSetTTBR0): EL1_OR_EL2_OR_EL3(x1) 1:msr ttbr0_el1, x0 // Translation Table Base Reg 0 (TTBR0) b 4f 2:msr ttbr0_el2, x0 // Translation Table Base Reg 0 (TTBR0) b 4f 3:msr ttbr0_el3, x0 // Translation Table Base Reg 0 (TTBR0) 4:isb ret
...But others in the same file, don't seem to support UEFI running in EL3:
ASM_PFX(ArmGetTTBR0BaseAddress): EL1_OR_EL2(x1) 1:mrs x0, ttbr0_el1 b 3f 2:mrs x0, ttbr0_el2 3:LoadConstantToReg(0xFFFFFFFFFFFF, x1) /* Look at bottom 48 bits */ and x0, x0, x1 isb ret
Does UEFI provide some placeholders to make vendor specific changes in the SEC or PEI phase to enable execution in EL3 mode?
Last I gathered from the discussions on the UEFI mailing lists, it seems that the some changes in PEI specs is required to accommodate ARM Trusted Firmware (ATF) and UEFI running in EL2. Where can I get more information on the same
Regards, Bhupesh