Hi Grant,
On 17 February 2011 05:56, Grant Likely grant.likely@secretlab.ca wrote:
On Sat, Feb 12, 2011 at 06:17:05PM +0530, Thomas Abraham wrote:
The default uart port register settings are obtained from the platform data. In addition to that, this patch adds support for obtaining the default uart port register values from the uart node in device tree.
Signed-off-by: Thomas Abraham thomas.abraham@linaro.org
drivers/tty/serial/samsung.c | 13 +++++++++++++ 1 files changed, 13 insertions(+), 0 deletions(-)
diff --git a/drivers/tty/serial/samsung.c b/drivers/tty/serial/samsung.c index 66fece9..dda1d52 100644 --- a/drivers/tty/serial/samsung.c +++ b/drivers/tty/serial/samsung.c @@ -1148,9 +1148,22 @@ int s3c24xx_serial_probe(struct platform_device *dev, { struct s3c24xx_uart_port *ourport; int ret;
- unsigned int len, *regdef;
- struct s3c2410_uartcfg *cfg;
dbg("s3c24xx_serial_probe(%p, %p) %d\n", dev, info, probe_index);
- if (dev->dev.of_node) {
- regdef = (u32 *)of_get_property(dev->dev.of_node,
- "reg-defaults", &len);
- if (regdef && (len / sizeof(unsigned int)) == 3) {
- cfg = s3c24xx_dev_to_cfg(&dev->dev);
- cfg->ucon = be32_to_cpu(regdef[0]);
- cfg->ulcon = be32_to_cpu(regdef[1]);
- cfg->ufcon = be32_to_cpu(regdef[2]);
- }
- }
Same comment as before, per-uart configuration belongs in each ports device tree node.
The above configuration is obtained from the uart device tree node (dev->dev.of_node).
Also, don't forget to add binding documentation do Documentation/devicetree/bindings for the properties that you define for the samsung uart.
Ok. The documentation will be added.
Thanks, Thomas.
g.