Hi there,
When booting linaro snapshots on my PandaBoard the system hangs a few seconds after the bash prompt is shown (sometimes a little earlier). My first step was to enable magic-sysrq but the system doesn't react on them. It looks like it's already powered off - very strange. I've tried various hwpacks and headless images and also an SD-card image that works works on a pandaboard of a colleague (20110127 hwpack with 20110126 headless) but everything fails with the same symptoms. I used two different power supplies and several SD cards - also no difference. The board itself doesn't seem to be defective as the ubuntu-netbook-10.10-preinstalled-netbook-armel+omap4.img runs flawlessly for hours. I replaced the 2.6.35 omap4 kernel of the ubuntu 10.10 image with a kernel built from the latest git://git.linaro.org/ubuntu/linux-linaro- natty.git - but then the board hangs again. Attached is the output of the serial console. Any hints/suggestions on how to get the linaro kernel working on this board are much appreciated.
Regards Ken