Hi Avik,
Would you be willing to try the instructions I created for this at:
https://wiki.linaro.org/Mentoring/KernelDeploy
Especially the section labeled:
#Deploying the kernel to the SD card
These instructions worked on my Overo board.
--Matt
On 01/31/2011 03:57 AM, Avik Sil wrote:
Hi,
I tried booting linux-linaro-2.6.37 kernel on my beagle board C4. I executed following:
- Installed linaro on a 4 GB SD card using linaro-image-tools 0.4.1 with
hwpack daily snapshot hwpack_linaro-omap3_20110125-0_armel_supported.tar.gz and linaro-natty-headless-tar-20101202-1.tar.gz. It was booting properly on my BB.
Cloned linux-linaro-2.6.37. Changed to source directory
make ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- omap2plus_defconfig
make ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- menuconfig (enabled
EARLY_PRINTK)
make ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- uImage
make ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- modules
make ARCH=arm CROSS_COMPILE=arm-linux-gnueabi- modules_install
INSTALL_MOD_PATH=/media/rootfs
- cp arch/arm/boot/uImage /media/boot; sync
Everything went on smoothly. Then I put the SD card on BB and powered it on. I got a kernel panic: http://paste.ubuntu.com/560562
Please help me figuring out the problem. Is it because I didn't create uInitrd? If so, then how to create it for ARM?
Regards, Avik
linaro-dev mailing list linaro-dev@lists.linaro.org http://lists.linaro.org/mailman/listinfo/linaro-dev