Zach,
I would sign up for your session but I am flying out Thursday to make a customer meeting Friday.
I am not real familiar with the Panda or Beagle boards, and have never used one. I took a look at the Panda board schematics and it's using the standard 14-pin JTAG connector, so all the standard CCS debug capabilities should be supported.
I believe the Beagle board also uses the standard 14-pin JTAG connector.
Here are a couple of links for debugging with the Beagle board:
http://processors.wiki.ti.com/index.php/Debugging_Beagle_with_an_XDS100 http://processors.wiki.ti.com/index.php/Debug_Access_Port_%28DAP%29
CCS will be supported on Linux. I have sent a request into our CCS Team to confirm the state of Linux support.
Regards, Doug
-----Original Message----- From: Zach Pfeffer [mailto:zach.pfeffer@linaro.org] Sent: Wednesday, May 04, 2011 1:11 PM To: Loïc Minier Cc: Deao, Douglas; linaro-dev@lists.linaro.org Subject: Re: STM at UDS-Budapest
Would you guys mind signing up for:
https://blueprints.launchpad.net/linaro-android/+spec/linaro-android-o-jtag
I think this topic would fit in well with that. Would you also mind sending some info about JTAG support for Panada and Beagle and when and if CCS will be supported on Linux?
-Zach
On 3 May 2011 06:37, Loïc Minier loic.minier@linaro.org wrote:
Hi
The attachment which was too big for the mailing-list is at: http://people.linaro.org/~lool/STMLinuxDriverWhitePaper_Rev0%202S.pdf
Cheers
Loïc Minier
linaro-dev mailing list linaro-dev@lists.linaro.org http://lists.linaro.org/mailman/listinfo/linaro-dev