On 2/24/2012 12:35 PM, Rajendra Nayak wrote:
On Friday 24 February 2012 05:02 PM, T Krishnamoorthy, Balaji wrote:
On Thu, Feb 23, 2012 at 5:31 PM, Rajendra Nayakrnayak@ti.com wrote:
Define dt bindings for the ti-omap-hsmmc, and adapt the driver to extract data (which was earlier passed as platform_data) from device tree.
Signed-off-by: Rajendra Nayakrnayak@ti.com
.../devicetree/bindings/mmc/ti-omap-hsmmc.txt | 31 +++++++++ drivers/mmc/host/omap_hsmmc.c | 68 ++++++++++++++++++++ 2 files changed, 99 insertions(+), 0 deletions(-) create mode 100644 Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt
diff --git a/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt b/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt new file mode 100644 index 0000000..e4fa8f0 --- /dev/null +++ b/Documentation/devicetree/bindings/mmc/ti-omap-hsmmc.txt @@ -0,0 +1,31 @@ +* TI Highspeed MMC host controller for OMAP
+The Highspeed MMC Host Controller on TI OMAP family +provides an interface for MMC, SD, and SDIO types of memory cards.
+Required properties: +- compatible:
- Should be "ti,omap2-hsmmc", for OMAP2/3 controllers
omap_hsmmc is applicable for omap2430 and omap3. omap2420 has non high speed controller mmci-omap - drivers/mmc/host/omap.c May be omap3-hsmmc compatible with omap2430 ?
Agree. I think its best in that case for me to define a compatible "ti,omap2430-hsmmc" for omap2430 and "ti,omap3-hsmmc" for omap3. Though the IP blocks are same, I cant think of some common compatible string without causing confusion.
It depends, can we detect that using HW revision? In that case, there is no need to differentiate again with compatible.
Regards, Benoit
- Should be "ti,omap4-hsmmc", for OMAP4 controllers
+- ti,hwmods: Must be "mmc<n>", n is controller instance starting 1 +- reg : should contain hsmmc registers location and length
+Optional properties: +ti,dual-volt: boolean, supports dual voltage cards +<supply-name>-supply: phandle to the regulator device tree node +"supply-name" examples are "vmmc", "vmmc_aux" etc +ti,bus-width: Number of data lines, default assumed is 1 if the property is missing. +cd-gpios: GPIOs for card detection +wp-gpios: GPIOs for write protection +ti,non-removable: non-removable slot (like eMMC)
+Example:
- mmc1: mmc@0x4809c000 {
- compatible = "ti,omap4-hsmmc";
- reg =<0x4809c000 0x400>;
- ti,hwmods = "mmc1";
- ti,dual-volt;
- ti,bus-width =<4>;
- vmmc-supply =<&vmmc>; /* phandle to regulator node */
- ti,non-removable;
- };
devicetree-discuss mailing list devicetree-discuss@lists.ozlabs.org https://lists.ozlabs.org/listinfo/devicetree-discuss