Hi,
For the last few days I've been fighting what I thought was a touchscreen software problem with the Origen.
I finally went back to a known good version and it didn't work either. I've figured out what happened to my board I'm just not sure why as there has been no mechanical stress on that connection. One of the connectors has become de-laminated so the signals aren't getting through.
I've attached a picture with the area of the fault indicated. Applying pressure to the indicted area re-establishes the connection.
Angus
Thanks Angus!
I updated your advice into the following:
https://wiki.linaro.org/Boards/Origen/Setup
Regards Sangwook
On 19 September 2011 00:35, Angus Ainslie angus.ainslie@linaro.org wrote:
Hi,
For the last few days I've been fighting what I thought was a touchscreen software problem with the Origen.
I finally went back to a known good version and it didn't work either. I've figured out what happened to my board I'm just not sure why as there has been no mechanical stress on that connection. One of the connectors has become de-laminated so the signals aren't getting through.
I've attached a picture with the area of the fault indicated. Applying pressure to the indicted area re-establishes the connection.
Angus
-- Angus Ainslie angus.ainslie@linaro.org Team Lead, Samsung Landing Team
Samsung mailing list Samsung@lists.linaro.org http://lists.linaro.org/mailman/listinfo/samsung
-
Angus Ainslie -
Sangwook Lee